Files
PX4-Autopilot/msg
Andrea Bernasconi 67f5c57e9a feat(GNSS): Introduce kinematic consistency check (#29660)
* feat(gnss): check that the position change matches the velocity

A receiver computes its position from the code (time of flight) and its
velocity from the Doppler shift. Multipath and other degradation hit the
two differently, so a degraded receiver's position change stops matching
its velocity, often before its reported accuracy shows it. The existing
drift checks compare the two only at rest on the ground.

The new strict check filters the position change rate minus the mean
velocity over about 1 s and fails above GNSS_REQ_POSVEL, also in flight,
so the selection prefers another receiver that passes. It is off by
default (GNSS_CHECK bit 12) until the threshold is tuned on logs; the
filtered value is logged in sensors_status_gnss either way.

Assisted-by: Claude:claude-opus-5-5
Signed-off-by: Andrea Bernasconi <andrea.bernasconi@auterion.com>

* fix(gnss): skip the position step at a fix type change in the consistency check

When a receiver starts or stops applying differential or RTK corrections,
its position steps by up to a few meters in one epoch while the Doppler
velocity is unaffected. That is a new solution, not degradation, and it
shouldn't demote a receiver that just reached RTK fixed. On a 10 Hz log
with DGPS dropping in and out, these steps drove the filtered value to
4.5 m/s; without them it peaks at 0.8 m/s, during a real vertical drift.

Only the interval spanning the change is skipped and the filter keeps its
state, so a receiver that keeps switching isn't blind for longer.

Assisted-by: Claude:claude-opus-5-5
Signed-off-by: Andrea Bernasconi <andrea.bernasconi@auterion.com>

* refactor(gnss): Reduce check description

* fix(GNSS): Make the feature enabled by default but with more margin

* fix(gnss): restrict the position/velocity consistency check to horizontal

Receivers that don't report the vertical velocity failed the check on any
climb. Merge the consistency tests into fewer cases.

Assisted-by: Claude:claude-opus-5-5
Signed-off-by: Andrea Bernasconi <andrea.bernasconi@auterion.com>

* refactor(gnss): mark the position/velocity consistency check as horizontal

The check only compares the horizontal position change with the horizontal
velocity. Name the parameter, flags and status field after that, so that a
vertical counterpart can be added later as GNSS_REQ_VPOSVEL / CHECK_VPOSVEL.

Assisted-by: Claude:claude-opus-5-5
Signed-off-by: Andrea Bernasconi <andrea.bernasconi@auterion.com>

* refactor(gnss): rename the position/velocity check to kinematic consistency

HPOSVEL read like a check on position and velocity separately, next to
HDRIFT and HSPEED. "Kinematic consistency" names the property being
tested and leaves room for a vertical counterpart (VKIN). Messages,
flag comments and the parameter's long description keep the plain
wording, since "kinematic" alone can be read as RTK.

Assisted-by: Claude:claude-opus-5-5
Signed-off-by: Andrea Bernasconi <andrea.bernasconi@auterion.com>

---------

Signed-off-by: Andrea Bernasconi <andrea.bernasconi@auterion.com>
2026-11-17 10:38:26 +01:00
..
2025-11-04 17:22:10 +01:00
2024-06-26 11:05:38 +02:00
2024-06-26 11:05:38 +02:00
2025-07-25 09:42:12 -08:00
2026-10-23 22:48:49 +02:00