PX4 never said in which frame fixed-wing pitch angles are given, and
FW_PSP_OFF was described as an offset added to the pitch setpoint and as
the angle of attack, which holds only for TECS and Stabilized mode, and
only in level flight measured from the body x-axis.
- Trimming guide: a side-view diagram of the body frame, the pitch angle
and FW_PSP_OFF, and where FW_PSP_OFF is used.
- Messages: state that pitch setpoints and limits are absolute, drop the
FRD frame tag on an Euler angle, correct the pitch range to +-pi/2,
and describe the TECS pitch integrator as a correction term.
Comment-only, so no message version change.
- Parameters: describe FW_PSP_OFF as the level-flight pitch, mark the
absolute pitch parameters as such, and describe the asymmetric
FW_MAN_P_MAX range with a non-zero FW_PSP_OFF.
Assisted-by: Claude:claude-opus-5-5
Signed-off-by: Silvan <silvan@auterion.com>
Add a WEIGHT_FUEL parameter for the mass of a full fuel load. When set,
the weight used for trim throttle, min/stall airspeed, and climb/sink
rate scaling is reduced by the burned fuel mass derived from
fuel_tank_status (filtered to reject sloshing). Disabled by default.
- if the height rate input into TECS is finite, use that one to
update a velocity reference generator
- if the velocity reference generator reports position locked or
height rate input is not finite, then run altidue reference generator
- run altitude controller only if altitue is controlled
if height_rate_setpoint is set, only use that one to update altitdue trajectory
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- update all msgs to be directly compatible with ROS2
- microdds_client improvements
- timesync
- reduced code size
- add to most default builds if we can afford it
- lots of other little changes
- purge fastrtps (I tried to save this multiple times, but kept hitting roadblocks)