Run() published heater_status at both GPIO edges, 200 Hz for a 100 Hz
controller, and the default log profile recorded it at full rate. At
100 % duty the off phase ran with a zero delay, so the element was
switched off and back on every period and heater_on read false for that
instant. heater_current and supply_voltage were battery_status.current_a
and voltage_v, already logged there, and nominal_multiplier read 0 unless
HEATERn_NOM_V compensation was active.
The off phase no longer publishes and is skipped at full duty; the status
goes out once per controller cycle with heater_on meaning the element is
driven this period. The two battery fields are removed (the voltage is
still read for the V_nom compensation), nominal_multiplier is 1 when no
scaling is applied, and heater_status is logged at 1 Hz by default.
Assisted-by: Claude:claude-fable-5
Signed-off-by: Jacob Dahl <dahl.jakejacob@gmail.com>
* feat(driver/heater): Add threshold to prevent the heater from always heating.
It only starts heating if the temperature drops below the specified threshold,
and continues until reset.
- update all msgs to be directly compatible with ROS2
- microdds_client improvements
- timesync
- reduced code size
- add to most default builds if we can afford it
- lots of other little changes
- purge fastrtps (I tried to save this multiple times, but kept hitting roadblocks)