* fix(boards): update STM32H7 bootloaders with ECC scrub and enable bl_update
The committed extras/*_bootloader.bin for every STM32H7 flash-parameter
target predate #27642, so none carry the uncorrectable-flash-ECC scrub
that keeps a torn parameter-flash write from bricking the board on every
boot. Rebuild each bootloader from current main with the release
toolchain (GCC 13.2.1) and enable CONFIG_SYSTEMCMDS_BL_UPDATE so the fix
can be applied in the field via SYS_BL_UPDATE without a debugger; the
~40-45 KB image is embedded in ROMFS only when the option is on.
ark/fpv drops LANDING_TARGET_ESTIMATOR to fit the embedded image,
x-mav/ap-h743v2 gets its first committed bin, and a stray duplicate
bootloader bin is removed from kakuteh7dualimu/extras.
Signed-off-by: Jacob Dahl <dahl.jakejacob@gmail.com>
* fix(boards): remove SCH16T from ARK FPV mavlink-dev.px4board
---------
Signed-off-by: Jacob Dahl <dahl.jakejacob@gmail.com>
* feat(boards): add support for AEDROXH7 flight controller
STM32H743-based FPV / racing flight controller from AEDROX.
Brings up:
- ICM-42688-P IMU on SPI2
- DPS310 baro on internal I2C2
- W25N NAND flash on SPI3 with littlefs at /fs/flash
- MAX7456 analog OSD on SPI1
- 8 motor outputs (TIM1 + TIM8) all bidirectional-DShot capable
- CAN1
- External I2C1 connector for compass / sensors
- 6 UARTs (TEL1, GPS1, RC, TEL2, ESC telemetry, debug console on UART8),
- Two user GPIOs on the M5-M8 connector, VTX power and camera-switch GPIOs,
buzzer on PA7 (active-buzzer transistor low-side switch), battery V/I sensing
via ADC1.
Board ID 1198 shared with ArduPilot's AP_HW_AEDROXH7 entry.
USB enumerates as 0x16D0:0x14FE with VENDORSTR "AEDROX".
Signed-off-by: Julian Oes <julian@oes.ch>
* docs(docs): Minor subedit
---------
Signed-off-by: Julian Oes <julian@oes.ch>
Co-authored-by: Hamish Willee <hamishwillee@gmail.com>
