Commit Graph
6 Commits
Author SHA1 Message Date
Jacob Dahl a617a1433c fix(mavsdk_tests): stabilize takeoff-and-hold altitude check
wait_until_altitude() returns on the first touch of the target band while
the vehicle is still climbing, so start_checking_altitude() latched the hold
reference mid-climb. The normal takeoff overshoot (~0.24 m) and slow VTOL
settle then exceeded the 0.15 m tolerance and the standard_vtol job failed
intermittently.

Wait for the overshoot to damp before capturing the reference, and restore
the 0.2 m tolerance established in #26106 (a later SIH rewrite had tightened
it back to 0.15 m). Steady-state hover holds to ~0.05 m, so the check stays
sensitive to real altitude-hold failures.

Signed-off-by: Jacob Dahl <dahl.jakejacob@gmail.com>
2026-07-22 16:17:17 +12:00
Julian Oes 9976825d80 test(mavsdk): loosen takeoff altitude reach tolerance to 0.1m
The 0.01m (1cm) tolerance was not reachable within the 15s sim-time
window for the standard_vtol, causing the takeoff-and-hold test to time
out. Use 0.1m, which still verifies altitude hold but is physically
achievable, and stays below the 0.15m hold-monitoring tolerance.

Signed-off-by: Julian Oes <julian@oes.ch>
2026-07-17 10:51:42 -05:00
Ramon Roche 9a446cce0c fix(mavsdk_tests): use simulation time for sleeps in basics test
Replace std::this_thread::sleep_for() with tester.sleep_for() to use
simulation-aware sleep that accounts for speed factor under lockstep.
2026-07-17 10:51:42 -05:00
Matthias Grob cf8a65c5dd test(mavsdk): switch tests to SIH simulator 2026-07-17 10:51:42 -05:00
Farhang 14186cf74f [Tests] [CI] fix flaky altitude SITL test (#26106)
* test: increase altitude tolerance to fix flaky test

Altitude tolerance increased from 0.1f to 0.15f to handle simulation
timing variations. Test was failing at 0.201m with 0.2m tolerance.

* test: increase altitude tolerance further to 0.3m

* ci: re-add branch trigger for SITL tests

* Revert "ci: re-add branch trigger for SITL tests"

This reverts commit e5e4c9637b.
2025-12-13 09:13:23 -09:00
Jacob Dahl 4c0a63f679 mavsdk_tests: add multicopter alt hold test (#24396)
* mavsdk_tests: add multicopter alt hold test

* fix test filter

* increase altitude tolerance to 10m as a test

* reduce to 1m tolerance

* increase to 5m tolerance

* increase to 2m tolerance

* reduce back to 1m

* delay 60 seconds

* fix log upload

* fix ulog upload path

* make altitude tolerance in tester.wait_until_altitude configurable

* fix lambda

* default arg in declaration

* tighten up tolerance
2025-03-21 16:21:10 -06:00