Implements a new GUIDED_COURSE navigator mode that maintains a constant
ground-track bearing, altitude, and airspeed without manual stick input.
The mode is activated via MAVLink and accepts real-time in-flight updates:
- MAV_CMD_GUIDED_CHANGE_HEADING (HEADING_TYPE_COURSE_OVER_GROUND): set course
- MAV_CMD_DO_CHANGE_ALTITUDE: adjust target altitude
- MAV_CMD_DO_CHANGE_SPEED: adjust target airspeed
On activation the vehicle captures its current velocity vector as the
initial course bearing. A valid horizontal velocity estimate (GPS or
dead-reckoning) is required; course commands are rejected if unavailable.
* forwarding offboard setpoints in modes using the external mode registration
* requesting offboard setpoint in RAPTOR
* adding old message versions
* bumping vehicle status
* adding message translations
* updating reference to versioned old message on previous translations
The failure_detector_status bitmask in vehicle_status duplicates the
separate FailureDetectorStatus topic. Remove it and read directly from
the dedicated topic in failureDetectorCheck and HIGH_LATENCY2.
-add new NAVIGATION_STATE_ALTITUDE_VOYAGER
-this mode does require manual control to enter
-but you can disable the manual control loss failsafe to continue
flying in case of manual control loss
-for MC: in throttle and yaw are controlled like in Altitude mode,
the tilt is controlled via integrated rate input (similar to Acro,
but with tilt limit)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
