* docs: add Integrated GCS page * docs(config): fix review findings on Integrated GCS page Integrated GCS units send manual control to PX4 either as MAVLink over telemetry or as an RC signal (e.g. Herelink's S.Bus air unit output), so the tip now covers both paths rather than pointing only to Joystick Setup. Also lead the intro with the main benefit (manual and GCS control in one unit), apply style-guide fixes, link the page from Manual Control, rename the WebP images that had a .png extension, and compress the SRoC image. Assisted-by: Claude:claude-opus-5-5 Signed-off-by: Hamish Willee <hamishwillee@gmail.com> * Deleted unnescessary Aeronav Image: docs/assets/peripherals/integrated_gcs/uxv_technologies_aeronav.webp * Delete unnescessary Micronav image: docs/assets/peripherals/integrated_gcs/uxv_technologies_micronav.webp * docs(config): add PX4 configuration section to Integrated GCS page The page listed devices but never said how to set PX4 up for one. Configuration depends on whether the unit sends manual control as MAVLink or as an RC signal, and with MAVLink control a single link loss triggers both the manual control and data link loss failsafes, so the new section covers manual control, telemetry, failsafes, arming and video for both. Also crop the G2Nav image, drop the Alpha G-Case Duo at the author's suggestion, and link the page from the config index, Joystick Setup, Basic Concepts and the RC receiver list. Assisted-by: Claude:claude-opus-5-5 Signed-off-by: Hamish Willee <hamishwillee@gmail.com> --------- Signed-off-by: Hamish Willee <hamishwillee@gmail.com> Co-authored-by: Hamish Willee <hamishwillee@gmail.com>
3.3 KiB
Standard Configuration
This section covers the common software configuration and calibration needed for most PX4 vehicles.
You must first load firmware and select your vehicle frame/type. Most other steps can be done out of order, except for tuning, which must be done last.
Preconditions
Before starting you should Download QGroundControl and install it on your desktop computer. Then open the QGC application menu ("Q" icon in the top-left corner) and choose Vehicle Setup in the Select Tool popup:
Configuration Steps
Firmware/Vehicle Selection
Motor/Actuator Setup
Sensor Calibration
- Sensor Orientation
- Magnetometer (Compass)
- Gyroscope
- Accelerometer
- Level Horizon
- Airspeed (Fixed-wing/VTOL only)
::: info Setup for these and other sensors is located in Sensor Hardware & Setup. :::
Manual Control Setup
Radio Control:
Joystick/GamePad:
Integrated GCS:
Safety Configuration
Tuning
Auto-tuning is supported, and recommended, on the following frames:
Video Guide
The video below shows most of the calibration process (it uses an older version of QGroundControl, but most of the process is unchanged).
Support
If you need help with the configuration you can ask for help on the QGroundControl Support forum.
See Also
- QGroundControl > Setup
- Flight Controller Peripherals - Setup specific sensors, optional sensors, actuators, and so on.
- Advanced Configuration - Factory/OEM calibration, configuring advanced features, less-common configuration.
- Vehicle-Centric Config/Tuning:
