PX4-Autopilot

templates

drivers: Sagetech MXS transponder support

2022-06-20 18:16:07 -04:00

tools

optical flow sensor pipeline overhaul

2022-06-20 20:56:56 -04:00

action_request.msg

…

actuator_armed.msg

…

actuator_controls_status.msg

…

actuator_controls.msg

use actuator_controls[8] for collective tilt for tiltrotor VTOL, instead of [4]

2022-05-03 15:11:21 +02:00

actuator_motors.msg

esc_report: add actuator_function

2022-05-12 07:58:56 +02:00

actuator_outputs.msg

hitl,sitl,sih: use separate actuator_outputs_sim for SYS_CTRL_ALLOC==1

2022-02-25 08:30:58 +01:00

actuator_servos_trim.msg

control_allocator: implement trim + slew rate limits configuration

2021-12-24 20:06:13 -05:00

actuator_servos.msg

…

actuator_test.msg

control_allocator: increase max num motors to 12

2022-05-10 08:57:39 +02:00

adc_report.msg

…

airspeed_validated.msg

…

airspeed_wind.msg

…

airspeed.msg

differential pressure remove filters from drivers and average in sensors/airspeed

2022-04-26 08:39:19 -04:00

autotune_attitude_control_status.msg

…

battery_status.msg

msg: Add full_charge_capacity_wh

2022-01-26 13:44:48 -05:00

button_event.msg

safety and safety button: refactoring #19413

2022-04-05 07:57:37 +02:00

camera_capture.msg

…

camera_status.msg

…

camera_trigger.msg

Fix camera trigger via MAVLink when camera capture feedback is enabled

2021-12-17 07:56:08 +01:00

cellular_status.msg

…

CMakeLists.txt

combine sensor_gps + vehicle_gps_position msgs (keeping separate topics)

2022-07-07 10:24:11 -04:00

collision_constraints.msg

…

collision_report.msg

…

commander_state.msg

Added VTOL Takeoff navigation mode (#19027 )

2022-02-15 14:56:57 +01:00

control_allocator_status.msg

control_allocator: remove failed motor from effectiveness

2022-05-12 07:58:56 +02:00

cpuload.msg

…

debug_array.msg

…

debug_key_value.msg

…

debug_value.msg

…

debug_vect.msg

…

differential_pressure.msg

differential pressure remove filters from drivers and average in sensors/airspeed

2022-04-26 08:39:19 -04:00

distance_sensor.msg

…

ekf2_timestamps.msg

…

esc_report.msg

esc_report: add actuator_function

2022-05-12 07:58:56 +02:00

esc_status.msg

…

estimator_aid_source_1d.msg

ekf2: use estimator_aid_source_1d message for airspeed fusion

2022-07-07 09:42:54 -04:00

estimator_aid_source_2d.msg

ekf2: estimator aid source status (starting with fake position)

2022-05-23 16:21:49 -04:00

estimator_aid_source_3d.msg

ekf2: estimator aid source status (GPS pos, GPS vel)

2022-05-23 16:21:49 -04:00

estimator_baro_bias.msg

…

estimator_event_flags.msg

ekf2: estimator aid source status (GPS pos, GPS vel)

2022-05-23 16:21:49 -04:00

estimator_gps_status.msg

ekf2: add new estimator_gps_status.msg

2022-02-21 08:58:59 -05:00

estimator_innovations.msg

ekf: add logging of range finder consistency check

2022-04-13 11:41:48 +02:00

estimator_selector_status.msg

…

estimator_sensor_bias.msg

…

estimator_states.msg

…

estimator_status_flags.msg

ekf: add logging for rng kinematic consistency check

2022-04-13 11:41:48 +02:00

estimator_status.msg

ekf: add range finder "faulty" status

2022-02-11 10:57:45 -05:00

event.msg

…

failure_detector_status.msg

failure_detector: add motor/ESC failure detection

2022-05-12 07:58:56 +02:00

follow_target_estimator.msg

New follow-me flight task

2022-06-16 16:14:57 -04:00

follow_target_status.msg

FollowMe : Replace First order target position filter with Second order position and velocity filter

2022-06-16 16:14:57 -04:00

follow_target.msg

New follow-me flight task

2022-06-16 16:14:57 -04:00

generator_status.msg

…

geofence_result.msg

Format whitespace and group checkall() methods together in geofence class.

2022-01-31 21:01:03 -05:00

gimbal_device_attitude_status.msg

mavlink: don't send gimbal_device_attitude_status

2022-02-07 19:21:15 -05:00

gimbal_device_information.msg

…

gimbal_device_set_attitude.msg

…

gimbal_manager_information.msg

…

gimbal_manager_set_attitude.msg

…

gimbal_manager_set_manual_control.msg

…

gimbal_manager_status.msg

…

gps_dump.msg

…

gps_inject_data.msg

UAVCAN Moving Baseline Working

2021-11-30 15:59:08 -05:00

heater_status.msg

…

home_position.msg

…

hover_thrust_estimate.msg

…

input_rc.msg

…

internal_combustion_engine_status.msg

…

iridiumsbd_status.msg

…

irlock_report.msg

…

landing_gear.msg

…

landing_target_innovations.msg

…

landing_target_pose.msg

…

led_control.msg

…

log_message.msg

…

logger_status.msg

…

mag_worker_data.msg

…

magnetometer_bias_estimate.msg

magnetometer allow setting initial calibration from bias if available and stable

2021-12-01 20:24:56 -05:00

manual_control_setpoint.msg

…

manual_control_switches.msg

manual_control: enable sending camera commands

2022-01-10 23:04:10 -05:00

mavlink_log.msg

…

mavlink_tunnel.msg

Enable logging of mavlink tunnel messages

2022-01-26 11:10:43 -05:00

mission_result.msg

…

mission.msg

…

mount_orientation.msg

…

navigator_mission_item.msg

…

npfg_status.msg

integrate optional NPFG library for wind-aware fixed-wing guidance

2022-01-14 22:05:53 +01:00

obstacle_distance.msg

…

offboard_control_mode.msg

…

onboard_computer_status.msg

…

orb_test_large.msg

…

orb_test_medium.msg

…

orb_test.msg

…

orbit_status.msg

…

parameter_update.msg

…

ping.msg

…

position_controller_landing_status.msg

…

position_controller_status.msg

…

position_setpoint_triplet.msg

…

position_setpoint.msg

FixedWingPositionControl: do not pass trim throttle via position setpoint triplet

2022-07-12 09:07:20 +02:00

power_button_state.msg

…

power_monitor.msg

…

pps_capture.msg

Remove PPS GPIO interrupt when the rate is higher than 20Hz

2022-07-04 11:32:33 +02:00

pwm_input.msg

…

px4io_status.msg

px4io: replace safety_off state with safety button event (#19558 )

2022-06-01 13:15:13 -04:00

radio_status.msg

…

rate_ctrl_status.msg

…

rc_channels.msg

…

rc_parameter_map.msg

…

rpm.msg

…

rtl_time_estimate.msg

Compute RTL time and react if lower than flight time

2021-11-24 14:10:24 +01:00

satellite_info.msg

…

sensor_accel_fifo.msg

…

sensor_accel.msg

…

sensor_baro.msg

sensors: add baro calibration and cleanup

2022-03-26 16:08:41 -04:00

sensor_combined.msg

Add gyro clipping to mirror accel clipping monitoring instances.

2022-05-18 21:16:05 -04:00

sensor_correction.msg

…

sensor_gnss_relative.msg

drives/gps: add new sensor_gnsss_relative msg

2022-03-29 07:59:41 +02:00

sensor_gps.msg

combine sensor_gps + vehicle_gps_position msgs (keeping separate topics)

2022-07-07 10:24:11 -04:00

sensor_gyro_fft.msg

…

sensor_gyro_fifo.msg

…

sensor_gyro.msg

Add gyro clipping to mirror accel clipping monitoring instances.

2022-05-18 21:16:05 -04:00

sensor_hygrometer.msg

msg: new sensor_hygrometer msg

2021-12-27 12:13:09 -05:00

sensor_mag.msg

sensors (accel/gyro/mag) determine if external with device id

2022-01-10 10:31:07 -05:00

sensor_optical_flow.msg

optical flow sensor pipeline overhaul

2022-06-20 20:56:56 -04:00

sensor_preflight_mag.msg

…

sensor_selection.msg

…

sensors_status_imu.msg

…

sensors_status.msg

sensors: add baro calibration and cleanup

2022-03-26 16:08:41 -04:00

system_power.msg

…

takeoff_status.msg

…

task_stack_info.msg

…

tecs_status.msg

log tecs trim throttle

2022-07-12 09:07:20 +02:00

telemetry_status.msg

mavlink increase HEARTBEAT timeout 1.5->2.5s

2022-02-18 10:16:20 -05:00

test_motor.msg

…

timesync_status.msg

…

timesync.msg

…

trajectory_bezier.msg

…

trajectory_setpoint.msg

trajectory_setpoint: correct comment typo "kinematically"

2022-05-12 17:19:48 +02:00

trajectory_waypoint.msg

…

transponder_report.msg

…

tune_control.msg

Reduce Beeepr Default volume : 40 -> 20, since it's too loud for TAP_ESC devices from Yuneec (#19311 )

2022-03-11 10:27:57 +01:00

uavcan_parameter_request.msg

…

uavcan_parameter_value.msg

…

ulog_stream_ack.msg

…

ulog_stream.msg

…

uwb_distance.msg

Support for NXP UWB position sensor

2022-04-04 17:26:52 +02:00

uwb_grid.msg

Support for NXP UWB position sensor

2022-04-04 17:26:52 +02:00

vehicle_acceleration.msg

…

vehicle_air_data.msg

sensors: add baro calibration and cleanup

2022-03-26 16:08:41 -04:00

vehicle_angular_acceleration_setpoint.msg

…

vehicle_angular_acceleration.msg

…

vehicle_angular_velocity.msg

…

vehicle_attitude_setpoint.msg

use actuator_controls[8] for collective tilt for tiltrotor VTOL, instead of [4]

2022-05-03 15:11:21 +02:00

vehicle_attitude.msg

Add gyro clipping to mirror accel clipping monitoring instances.

2022-05-18 21:16:05 -04:00

vehicle_command_ack.msg

Move Vehicle Command Result Enum defs to Vehicle Command Ack (#19729 )

2022-07-07 16:15:11 +02:00

vehicle_command.msg

Move Vehicle Command Result Enum defs to Vehicle Command Ack (#19729 )

2022-07-07 16:15:11 +02:00

vehicle_constraints.msg

…

vehicle_control_mode.msg

…

vehicle_global_position.msg

…

vehicle_imu_status.msg

Add gyro clipping to mirror accel clipping monitoring instances.

2022-05-18 21:16:05 -04:00

vehicle_imu.msg

Add gyro clipping to mirror accel clipping monitoring instances.

2022-05-18 21:16:05 -04:00

vehicle_land_detected.msg

move vehicle at rest detection ekf2 -> land_detector

2022-02-01 17:50:19 -05:00

vehicle_local_position_setpoint.msg

vehicle_local_position_setpoint: reorder fields for clarity

2022-05-12 17:19:48 +02:00

vehicle_local_position.msg

small typo in vehicle_local_position msg

2021-12-17 15:45:07 +01:00

vehicle_magnetometer.msg

…

vehicle_odometry.msg

add odometry reset counter (ekf2, mavlink, etc)

2022-01-31 09:19:36 -05:00

vehicle_optical_flow_vel.msg

optical flow sensor pipeline overhaul

2022-06-20 20:56:56 -04:00

vehicle_optical_flow.msg

optical flow sensor pipeline overhaul

2022-06-20 20:56:56 -04:00

vehicle_rates_setpoint.msg

…

vehicle_roi.msg

…

vehicle_status_flags.msg

Commander: remove system_sensors_initialized

2022-06-15 14:02:00 -04:00

vehicle_status.msg

Style refactoring related to safety button

2022-06-08 05:12:05 -04:00

vehicle_thrust_setpoint.msg

vehicle_{thrust,torque}_setpoint.msg: fix comment

2022-04-28 19:51:28 -04:00

vehicle_torque_setpoint.msg

vehicle_{thrust,torque}_setpoint.msg: fix comment

2022-04-28 19:51:28 -04:00

vehicle_trajectory_bezier.msg

…

vehicle_trajectory_waypoint.msg

…

vtol_vehicle_status.msg

VTOL: remove some unsued variables

2022-05-18 10:01:04 +02:00

wheel_encoders.msg

…

wind.msg

…

yaw_estimator_status.msg

ekf2: yaw estimator add yaw_composite_valid boolean

2022-06-01 13:16:06 -04:00