Files
PX4-Autopilot/docs/en/releases
fe0662edb1 fix(fixed-wing): Update underspeed detection thresholds, add bank limiting (#26859)
Underspeed mitigation used to ramp in from tas_min - 0.15*trim and only
reached full effect at tas_min - 0.30*trim. On typical airframes this was
below stall, so in practice the protection never kicked in.

- Start the ramp at tas_min. It reaches full effect at 90% of tas_min, or
  halfway to tas_stall if that is higher (a step if stall >= min). The
  stall airspeed comes from FW_AIRSPD_STALL via the performance model and
  is load-factor and flaps compensated, like the minimum airspeed. Drop
  the hardcoded tas_error_percentage.
- While the underspeed ratio is above 0.5, reset the altitude reference to
  the current state. This stops altitude error from building up and then
  commanding a hard pitch-up (and a possible secondary stall) on recovery.
- Blend the roll limit from FW_R_LIM down to min(20 deg, FW_R_LIM) as the
  underspeed ratio rises, ahead of the roll slew-rate limit, to reduce load
  factor during recovery.
- Add TECS unit tests for the ramp, the stall handling and the altitude
  reference hold.

Takeoff and landing turn underspeed protection off, so none of this
applies there.

---------

Signed-off-by: RomanBapst <bapstroman@gmail.com>
Co-authored-by: RomanBapst <bapstroman@gmail.com>
Co-authored-by: Silvan Fuhrer <silvan@auterion.com>
2026-10-15 12:08:57 +00:00
..