# Surface Vehicle Course Setpoint # # Course setpoint for surface vehicles, on land or on water (rovers, boats). # Consumed by the position controllers of these vehicles (currently AckermannPosControl, # DifferentialPosControl and MecanumPosControl), which turn it into speed and attitude # setpoints. # Published by the Guided Course mode of rover_ackermann, rover_differential and rover_mecanum, # and can be sent from ROS 2 over uXRCE-DDS (/fmu/in/surface_vehicle_course_setpoint). # The vehicle tries to track the course over ground, as with the fixed-wing course hold: vehicles # that steer by heading correct their heading by the estimated drift angle, mecanum rovers drive # along the course setpoint directly. There is no desired track, so a sideways offset is not # corrected. To follow a desired track, publish rover_position_setpoint instead. # The position controller follows whichever of the two was published most recently. uint64 timestamp # [us] Time since system start float32 course # [rad] [@range -pi, pi] [@frame NED] [@invalid NaN No course; the position controller stays idle] Course over ground to hold float32 speed # [m/s] [@range -inf, inf] [@invalid NaN Defaults to maximum speed] Cruising speed; a negative value drives the vehicle in reverse (rear first) along the course float32 yaw # [rad] [@range -pi, pi] [@frame NED] [@invalid NaN Not considered] Currently unused. Only for vehicles that can move sideways (e.g. mecanum rovers): vehicle yaw while holding the course.